LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2017 >> Pacifica Hybrid Premium >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Electronic Control Modules (Service Information)) >> Module, Park Assist (PAM) >> Removal And Installation >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Position the Park Assist Module (PAM) to the right quarter inner panel, to the rear of the C-pillar and above the right rear wheel house.
  2. Install the plastic push-in fasteners that secures the PAM to the right quarter inner panel.
  3. Depending on the system in use, connect either two body or three wire harness connectors to the PAM connector receptacles.
  4. Install the trim onto the right quarter inner panel. Refer to PANEL, QUARTER TRIM, REMOVAL AND INSTALLATION .
  5. Connect the negative cable to the battery.