With Trailer Tow: Removal
WARNING: This page is about a different variant/trim than selected.
multimedia:A supplement to the article is available.
- Disconnect and isolate the battery negative cable.
- Remove the rear fascia. Refer to FASCIA, REAR, REMOVAL AND INSTALLATION
.
- Disconnect the body wiring harness connector (1) from the Hands Free Entry Power Liftgate (HFEPLG) module
- Remove the fasteners (1) securing the HFEPLG module with sensor assembly to the vehicle.
- Loosen the wiring harness from any tie down straps (1) between the two sensors with modules.
- Slide the wiring harness over the trailer tow hitch (1).
- Remove the HFEPLG module with sensor from the vehicle.