Description And Operation: Operation
All climate control communications take place on the CAN-I bus. HVAC control logic takes place in an HVAC module. All front and rear HVAC control logic is contained in the front HVAC module.
The purpose of the rear HVAC module is to follow CAN-I commands from the front HVAC module and position the rear HVAC doors and rear blower only.
It also reads the rear HVAC unit duct sensor and sends that value to the front HVAC module over CAN-I.
Front HVAC Module
The front HVAC module is responsible for controlling the following MTC/ATC Systems:
- Air distribution modes (actuators)
- Blower motor speed
- Air recirculation/vent modes
The front HVAC module receives input from the following sensors:
- Evaporator temperature sensor
- Sun load sensor
- Cabin temperature sensor
- Humidity sensor
If equipped with 3-Zone ATC:
- Left floor temperature sensor
- Right floor temperature sensor
- Left panel temperature sensor
- Right panel temperature sensor
Rear HVAC Module
The rear HVAC module is responsible for controlling the following MTC/ATC Systems:
- Air distribution mode (actuator)
- Blower motor speed
- Air recirculation/vent modes
The rear HVAC black box module receives input from the following sensors (If equipped with 3-Zone):
- Rear floor temperature sensor
- Rear panel temperature sensor