LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2017 >> Pacifica Hybrid Premium >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Electronic Control Modules (Service Information)) >> Module, Active Noise Cancellation (ANC) >> Removal And Installation >> Removal And Installation - Module >> Removal

Removal And Installation - Module: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the glove box. Refer to GLOVE BOX, INSTRUMENT PANEL, REMOVAL AND INSTALLATION .
  3. Remove the right front floor distribution duct. Refer to DUCT, FLOOR DISTRIBUTION, REMOVAL AND INSTALLATION .
  4. Disconnect the wire harness connectors from the amplifier.
    GC0177376Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Once the glove box and hush panel are remove, this is an access hole (1) for the top amplifier bolt.

    GC0177988Courtesy of CHRYSLER GROUP, LLC

    HVAC assembly removed for clarity

  5. Remove the amplifier bracket to instrument panel carrier frame bolts (1).
  6. Remove the amplifier and bracket (1).