LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 Base, Gas/Ethanol >> Repair and Diagnosis >> Engine Performance >> Ignition System (Service Information) >> SENSOR, Camshaft Position >> Installation >> 5.7L

SENSOR, Camshaft Position: Installation: 5.7L

CAUTION:

Install the camshaft position (CMP) sensor utilizing a slight rotating (side-to-side) motion. Make sure the CMP sensor is fully seated. Do not drive the CMP sensor into the bore with the mounting screw. This may cause the CMP sensor to be incorrectly seated causing a faulty signal or no signal at all.

CAUTION:

Before tightening the sensor mounting bolt, be sure the sensor is completely flush to the timing chain cover. If the sensor is not flush, damage to sensor mounting tang may result.

Fig 1: Camshaft Position Sensor-5.7L
GC0095240Courtesy of CHRYSLER LLC
NOTE:

Lubricate the CMP sensor O-ring with clean engine oil to aid in the installation.

  1. Install the CMP sensor (1) into the timing chain cover (2) while using a slight rotating motion.
  2. Install the retaining bolt (3) and tighten to 12 N.m (9 ft. lbs.).
  3. Connect the CMP sensor electrical connector (4).
    Fig 2: Engine Cover
    GC0143807Courtesy of CHRYSLER LLC
  4. Position the engine cover (1) and secure the retaining grommets onto the ball studs.
    Fig 3: Negative Battery Cable
    GC0139402Courtesy of CHRYSLER LLC
  5. Connect the negative battery cable and tighten nut (1) to 5 N.m (45 in. lbs.).