LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> Sebring Base, 2D Convertible, ED3 >> Repair and Diagnosis >> Steering >> Steering Column >> Steering System >> Pump >> HOSE, Power Steering, Pressure >> Removal >> 2.7L Engine

2.7L Engine

NOTE: Before proceeding. See Steering - Warning .
Fig 1: RETURN HOSE AT TUBE TO GEAR
GC0082526Courtesy of CHRYSLER LLC
  1. Siphon as much fluid as possible from the power steering fluid reservoir.
  2. Raise and support the vehicle. Refer to Vehicle Quick Reference/Hoisting - Standard Procedure .
  3. Remove the return hose (1) at the return tube (2) and allow any fluid in the hose to drain. If equipped with a screw-clamp, be sure to save the original clamp for reinstallation.
    Fig 2: PRESSURE HOSE AT PUMP - 2.7L
    GC0122202Courtesy of CHRYSLER LLC
  4. Remove the pressure hose (2) at the pump (1).
    Fig 3: HOSES AT GEAR
    GC0122200Courtesy of CHRYSLER LLC
  5. Unscrew the tube nut (2), then remove the return hose (1) at the steering gear.
  6. Unscrew the tube nut (3), then remove the pressure hose (4) at the steering gear.
    Fig 4: HOSES AT REAR OF CROSSMEMBER
    GC0120780Courtesy of CHRYSLER LLC
  7. Remove the screws (1) securing the power steering hose routing clamps (2) to the rear of the crossmember.
  8. Remove the power steering pressure hose from the vehicle.