LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> Sebring Base, 2D Convertible, ED3 >> Repair and Diagnosis >> Steering >> Steering Column >> Steering System >> Pump >> HOSE, Power Steering, Pressure >> Removal >> 2.0L Diesel Engine

2.0L Diesel Engine

NOTE: Before proceeding. See Steering - Warning .
Fig 1: PRESSURE LINE
GC0082522Courtesy of CHRYSLER LLC
  1. Siphon as much fluid as possible from power steering fluid reservoir.
  2. Remove the engine appearance cover.
  3. Remove the pressure line (3) at the pump (4).
  4. Remove the pressure line routing bracket bolt (2) at the upper mount (7).
  5. Raise and support the vehicle. Refer to Vehicle Quick Reference/Hoisting - Standard Procedure .
    Fig 2: RETURN HOSE AT TUBE TO GEAR
    GC0082526Courtesy of CHRYSLER LLC
  6. Remove the return hose (1) at the return tube (2) and allow any fluid in the hose to drain. If equipped with a screw-clamp, be sure to save the original clamp for reinstallation.
  7. Remove belly pan below engine.
    Fig 3: PRESSURE HOSE ROUTING CLAMP
    GC0122208Courtesy of CHRYSLER LLC
  8. Remove the routing clamp screw (1) securing the pressure hose (2) to the right side of the crossmember (3).
    Fig 4: HOSES AT GEAR
    GC0122200Courtesy of CHRYSLER LLC
  9. Unscrew the tube nut (3), then remove the pressure hose (4) at the steering gear.
    Fig 5: HOSES AT REAR OF CROSSMEMBER
    GC0120780Courtesy of CHRYSLER LLC
  10. Remove the screws (1) securing the power steering hose routing clamps (2) to the rear of the crossmember.
  11. Remove the power steering pressure hose from the vehicle.