LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> Sebring Base, 2D Convertible, ED3 >> Repair and Diagnosis >> Steering >> Steering Column >> Steering System >> Pump >> HOSE, Power Steering, Pressure >> Installation >> Right-Hand-Drive - 2.7L Engine

Right-Hand-Drive - 2.7L Engine

CAUTION: Power steering fluid hoses must remain away from the exhaust system, driveshafts, vehicle components and any unfriendly surface that can possibly damage the hoses.
Fig 1: Hoses At RHD Gear
GC0098924Courtesy of CHRYSLER LLC
  1. Using a lint free towel, wipe clean the open power steering hose end and the power steering gear port. Replace any used O-rings with new. Lubricate the O-ring with power steering fluid.
  2. Install the power steering pressure hose into the engine compartment from below.
  3. Install the pressure hose at the gear. Tighten the tube nut (2) to 32 N.m (24 ft. lbs.).
    Fig 2: PRESSURE HOSE AT PUMP - 2.7L
    GC0122202Courtesy of CHRYSLER LLC
  4. Using a lint free towel, wipe clean the open power steering pressure hose end and the power steering pump port. Replace any used O-rings with new. Lubricate the O-ring with clean power steering fluid.
  5. Install the pressure hose (2) at the pump pressure port. Tighten the tube nut to 32 N.m (24 ft. lbs.).
  6. Lower the vehicle.
  7. Fill and bleed the power steering system. See Steering - Standard Procedure .
  8. Check for leaks.