LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> Sebring Base, 2D Convertible, ED3 >> Repair and Diagnosis >> Steering >> Steering Column >> Steering System >> Pump >> HOSE, Power Steering, Pressure >> Installation >> 2.0L Diesel Engine

2.0L Diesel Engine

CAUTION: Power steering fluid hoses must remain away from the exhaust system, driveshafts, vehicle components and any unfriendly surface that can possibly damage hoses.
Fig 1: HOSES AT GEAR
GC0122200Courtesy of CHRYSLER LLC
  1. Install the pressure hose tube (4) at the gear. Tighten the tube nut (3) to 32 N.m (24 ft. lbs.).
    Fig 2: HOSES AT REAR OF CROSSMEMBER
    GC0120780Courtesy of CHRYSLER LLC
  2. Position the power steering hose routing clamps (2) on the crossmember. Install and tighten the screws to 8 N.m (71 in. lbs.).
    Fig 3: PRESSURE HOSE ROUTING CLAMP
    GC0122208Courtesy of CHRYSLER LLC
  3. Position the power steering hose (2) routing clamp at the right side of the crossmember (3). Install and tighten the routing clamp screw (1) to 8 N.m (71 in. lbs.).
  4. Install the belly pan below the engine.
    Fig 4: RETURN HOSE AT TUBE TO GEAR
    GC0082526Courtesy of CHRYSLER LLC
  5. Install the return hose (1) at the return tube (2) and install the clamp. If a screw-clamp is used, tighten it to 2.5 N.m (20 in. lbs.).
  6. Lower the vehicle.
    Fig 5: PRESSURE LINE
    GC0082522Courtesy of CHRYSLER LLC
  7. Install the pressure line (3) at the pump pressure port (4). Tighten the tube nut to 32 N.m (24 ft. lbs.).
  8. Install the pressure line routing bracket bolt (2) to the engine mount (7). Tighten the bolt to 24 N.m (18 ft. lbs.).
  9. Fill and bleed the power steering system. See Steering - Standard Procedure .
  10. Check for leaks.
  11. Install the engine appearance cover.