LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> PT Cruiser Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Steering >> Steering Column >> Steering System >> Gear >> Power Steering Pressure Switch >> Removal

Power Steering Pressure Switch: Removal

NOTE: Before proceeding, (Refer to STEERING - WARNING) .
  1. Disconnect negative battery cable from the negative post of the battery. Be sure cable is isolated from negative post on battery.
  2. Raise the vehicle. (Refer to LUBRICATION & MAINTENANCE/HOISTING - STANDARD PROCEDURE) .
  3. Locate the power steering fluid pressure switch on the back side of the power steering gear. See Fig 1.
    Fig 1: Power Steering Fluid Pressure Switch
    GC0019526Courtesy of DAIMLERCHRYSLER CORP.
    1 - WIRING HARNESS CONNECTOR
    2 - POWER STEERING GEAR
    3 - POWER STEERING FLUID PRESSURE SWITCH
    4 - REAR OF FRONT SUSPENSION CROSSMEMBER
  4. Remove the vehicle wiring harness connector from the power steering fluid pressure switch.
    NOTE: When removing and installing the power steering pressure switch, use a 7/8 inch deep well socket. The deep well socket will prevent damage to the plastic electrical connector area of the power steering fluid pressure switch.
  5. Unscrew and remove the power steering fluid pressure switch from the power steering gear.