LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> 300 Base >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.7L DOHC Engine (Service Information) >> Collar-Structural >> Installation

2.7L DOHC Engine (Service Information): Collar-Structural: Installation

Fig 1: REMOVE STRUCTURAL COLLAR
GC0015346Courtesy of DAIMLERCHRYSLER CORP.
  1. Install structural collar (1) from the right rear.
    Fig 2: Structural collar
    GC0015227Courtesy of DAIMLERCHRYSLER CORP.
    CAUTION: The structural collar must be tightened using this service procedure, or damage to transmission case and/or oil pan may occur.
  2. Position structural collar (3) in place.
  3. Finger tighten all bolts (2,4).
    NOTE: Make sure that structural collar (3) is flush with the oil pan (1) and the transmission bell housing.
  4. Install the vertical collar bolts (2) to oil pan, pre-torque bolts to 1.1 N.m ( 10 in. lbs.).
  5. Install the horizontal collar bolts (4) to transmission and tighten to 55 N.m ( 40 ft. lbs.).
  6. Starting with the center vertical bolts and working outward, final torque all bolts to 55 N.m ( 40 ft. lbs.).
    Fig 3: Lower Splash Shield
    GC0015233Courtesy of DAIMLERCHRYSLER CORP.
  7. Install lower splash shield (2) and retaining bolts (1).
  8. Lower vehicle.
    Fig 4: Battery
    GC0015222Courtesy of DAIMLERCHRYSLER CORP.
  9. Connect negative battery (1) cable.