LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2004 >> Intrepid SXT >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Exhaust Gas RECIRCULATION System >> EGR Tube-3.5L >> Installation - 3.5L

Installation - 3.5L

The EGR tube attaches to the bottom of the intake manifold plenum beside the throttle body (Figure).

  1. Install rubber silicone seals on intake manifold end of EGR tube, being careful to be sure silicone rubber seals is correctly installed and undamaged.
  2. Using a new gasket, loosely install the EGR tube into the intake manifold and loosely install EGR tube to EGR valve.
  3. Tighten the EGR tube to EGR valve screws to 11 N.m (95 in.lbs.) torque.
  4. Install clips for the EGR tube to intake manifold plenum (Fig 1).
  5. Install transmission to throttle body bracket.
  6. Install air inlet tube and resonator.
  7. Connect negative battery cable.
    Fig 1: EGR tube Seal
    G03499012Courtesy of DAIMLERCHRYSLER CORP.