Diagnosis And Testing - Driver Heated Seat Switch: Notes
Inspect the Heated Seat Switch for apparent damage or sticking/binding condition, replace if necessary. Refer to REMOVAL and INSTALLATION . For circuit description and diagrams, refer to SYSTEM WIRING DIAGRAMS .
- Remove the heated seat switch from its mounting location. Refer to REMOVAL and INSTALLATION .
- Using an ohm meter, check the ground circuit cavity of the heated seat switch electrical connector for a good continuity to ground. If OK, go to Step 3. If not OK, repair the open ground circuit as required.
- Turn the ignition switch to the RUN position. Using an volt meter, check the 12v (B+) circuit cavity of the heated seat switch electrical connector for 12v. If OK, go to Step 4. If not OK, repair the open or shorted 12v B+ circuit as required.
- Turn the ignition switch OFF. Using an ohm meter, check the continuity between pin 4 and pin 6 of the heated seat switch, while in its neutral, LO and HI positions. Measure the resistance between the two pins and compare with the chart below (Fig 1 ). If the readings do not correspond to those in the Heated Seat Switch Continuity table, replace the heated seat switch.