Tire Pressure Verification Test

1. Perform the EVIC training as instructed in the System Description.
2. Using the DRBIII® or the EVIC RESET button, set the EVIC to Diagnostics mode (blank screen).
3. NOTE: Set the EVIC as follows:
4. Press and hold the EVIC RESET button for five seconds (EVIC will beep).
5. Set the EVIC to display BLOCK COUNTERS.
6. NOTE: A vehicle graphic will display showing counters at wheel locations.
7. Drive the vehicle at 40 km/h (25 mph) for at least 2 minutes.
8. Observe that the counters increment at least 3 sensor/transmitter receptions for each wheel.

Can the EVIC be trained and do the counters show Sensor/Transmitter receptions?

• Yes: Repair is complete.
• No: Refer to Diagnosing System Faults in the Description and Operation for this system.