LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2004 >> Crossfire Automatic >> Repair and Diagnosis >> Suspension >> Front Suspension >> Removal & Installation >> Stabilizer Bar >> Installation

Stabilizer Bar: Installation

  1. Install both right and left stabilizer bar bushings onto the stabilizer bar.
  2. NOTE: The lower control arms may need to be raised to accept the stabilizer bar bushing to its mating surface.
  3. Install the stabilizer bar to the vehicle by loosely installing the bolts and nuts to all 4 brackets.
  4. Align the stabilizer bar so it is centered in the vehicle.
  5. NOTE: Due to the preload of the bracket, install the center hexagon socket bolt first.
  6. Tighten both stabilizer bar bolts to frame.
  7. Tighten both stabilizer bar hexagon socket bolts to the retainer.
  8. Tighten both right and left stabilizer bar bracket nuts to the lower control arm to specification. See TORQUE SPECIFICATIONS  .
  9. Install the stabilizer bar retainer and mounting plate (if removed).
  10. Tighten the retainer bolt to frame (if removed) to specification. See TORQUE SPECIFICATIONS  .
  11. Tighten the lower retainer nut to the fastening bracket (if removed) to specification. See TORQUE SPECIFICATIONS  .
  12. Tighten upper retainer lever nut to the fastening bracket (if removed) to specification. See TORQUE SPECIFICATIONS  .
  13. Lower the vehicle and check vehicle alignment. See appropriate SPECIFICATIONS & PROCEDURES article in WHEEL ALIGNMENT.