Ball Joint Checking
Ball joints are maintenance free (no grease fitting). Check the lower control arm supporting ball joint by performing the following:
- Remove the nut from the lower control arm supporting ball joint. See Fig 1 .
- Using Ball Joint Puller (9168), press out the lower control arm supporting ball joint from the steering knuckle. See Fig 2 .
- Check the lower control arm supporting ball joint. It should be possible to move the ball pivot without any play, jamming or creaking noises. Move the ball pivot in all directions with a tube approximately 6" (150 mm) in length. Check the boot for any cracks or damage. If the boot is leaking, replace supporting or follower joint.