LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2000 >> Sebring LX >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Diagnosis - F4AC1 Automatic Transmission >> Component Tests >> Transaxle Control Relay

Transaxle Control Relay

NOTE: Transaxle control relay may also be referred to as EATX relay.
  1. Disconnect transaxle control relay harness connector and remove relay from firewall bracket. See Figure . Check for continuity between relay terminals No. 4 and 6. See Figure . If continuity exists, go to next step. If continuity does not exist, replace relay.
  2. Using jumper wires, connect positive battery terminal to relay terminal No. 4, and negative battery terminal to relay terminal No. 6. Check for continuity between relay terminals No. 2 and 8. Continuity should exist. Remove jumper wires. Continuity should no longer exist. Replace relay if continuity check is not as specified.
scientia non olet · About LEMON Manuals