LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2000 >> Intrepid ES >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (Engine Cooling System) >> Water Pump - 3.5L >> Removal

Water Pump - 3.5L: Removal

WARNING: This page is about a different car, the 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, and 2003 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.

The water pump on all models can be replaced without discharging the air conditioning system.

WARNING: DO NOT REMOVE PRESSURE CAP WITH THE SYSTEM HOT AND UNDER PRESSURE BECAUSE SERIOUS BURNS FROM COOLANT CAN OCCUR.
NOTE: It is normal for the water pump to weep a small amount of coolant from the weep hole (black stain on water pump body). Do not replace the water pump if this condition exists. Replace the water pump if a heavy deposit or a steady flow of engine coolant is evident on water pump body from the weep hole (shaft seal failure). Be sure to perform a thorough analysis before replacing water pump.
  1. Drain cooling system.
  2. Remove accessory drive belts (Refer to ACCESSORY DRIVE ).
    NOTE: The water pump is driven by the timing belt.
  3. Remove engine timing belt. Refer to appropriate ENGINE article.
  4. Remove water pump mounting bolts (Fig 1 ). Note position of longer bolt for proper reinstallation.
  5. Remove water pump body from engine (Fig 1 ).
    Fig 1: Removing Bolts Of Water Pump - 3.5L Engine
    G02709143Courtesy of DAIMLERCHRYSLER CORP.