Installation (Inner CV Boot)
NOTE:
The inner tripod spider boots are made of silicone rubber which is soft and pliable. Replacement sealing boot must be the same type of material as the sealing boot which was removed.
- Slide NEW CV boot clamp onto axle shaft. Install NEW CV boot. Install tripod spider onto axle shaft. Install tripod spider retainer snap ring. Ensure spider retainer snap ring is fully seated into axle shaft groove. Using grease provided in CV boot service package, distribute 1/2 of grease into tripod housing. DO NOT use any other type of grease. Put remaining grease into CV boot. Slide tripod spider into tripod joint housing.
- Position small end of CV boot onto boot retaining groove on axle shaft. Ensure bead inside CV boot is seated in groove on axle shaft. Install small CV boot clamp evenly over boot. Crimp bridge of boot clamp using Clamp Installer (C-4975). See Fig 1 . Position large end of CV boot onto tripod housing retaining groove.
- After CV boot is positioned correctly onto tripod housing, use clamp installer and crimp large CV boot clamp. To complete installation, reverse removal procedure. Tighten nuts and bolts to specification. See TORQUE SPECIFICATIONS .
NOTE:
Inner tripod spider boot must be positioned on axle shaft so only thinnest groove on axle shaft is visible.
CAUTION:
Seal must not be dimpled, stretched or out of shape in any way. If seal is not shaped correctly, equalize pressure in seal and shape by hand.