LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2000 >> Intrepid ES >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Self-Diagnostic System >> Retrieving Diagnostic Trouble Codes (DTCS)

Retrieving Diagnostic Trouble Codes (DTCS)

  1. Diagnostic Trouble Codes (DTCs) are retrieved using a scan tool. Attempt to start engine. Crank engine for up to 10 seconds (if necessary).
  2. Connect scan tool to Data Link Connector (DLC). DLC is located right of steering column next to center console. See Figure. Using scan tool manufacturer's instructions, read DTC message and code.
  3. If DTCs are displayed, note DTCs and perform appropriate test(s). See DTC MESSAGES & CODES  table. If no DTCs are displayed, refer to one of the following:
    • For driveability problems, see appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE.
    • For no-start problems, see appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE.
    • For speed (cruise) control problems, perform CHECKING SPEED CONTROL OPERATION - NO DTCS  under SYSTEM TESTS.
    • For charging system problems, see appropriate GENERATORS & REGULATORS article in STARTING & CHARGING SYSTEMS.
  4. To erase DTCs after repairs, go to CLEARING DIAGNOSTIC TROUBLE CODES .
DTC MESSAGES & CODES

DTC Scan Tool Message
DTC P0500  NO VEHICLE SPEED SENSOR SIGNAL
DTC P0703  BRAKE SWITCH STUCK PRESSED OR RELEASED
DTC P1595  SPEED CONTROL SOLENOID CIRCUITS
DTC P1597  SPEED CONTROL SWITCH ALWAYS LOW
DTC P1683  SPEED CONTROL POWER RELAY CIRCUIT, OR 12V DRIVER CIRCUIT
DTC P1899  PARK/NEUTRAL SWITCH STUCK IN PARK OR IN GEAR