LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2000 >> Intrepid Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Seat Heating System) >> Heated Seat Sensor >> Diagnosis And Testing - Heated Seat Sensor

Diagnosis And Testing - Heated Seat Sensor

WARNING: This page is about a different car, the 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, and 2003 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.

For complete circuit diagrams, refer to SYSTEM WIRING DIAGRAMS .

  1. Obtain a DRB III(R) scan tool if a DRB scan tool is not available a accurate voltmeter will also work.
  2. If using a DRB III(R), navigate through the following path on the DRB display screen, Body/Memory Seat Module/Sensor Display. Under Sensor Display you will find RT Seat Temp Volts - and LT Seat Temp Volts, compare the voltage reading with the table shown (Fig 1 ). If the voltage is not within specification, replace the heated seat element.
  3. If using a voltmeter, backprobe the sensor return signal circuit at the module and compare the voltage reading with the table shown (Fig 1 ). Refer to DIAGNOSIS AND TESTING - HEATED SEAT ELEMENT  for additional instructions. If the voltage is not within specification, replace the heated seat element.
    Fig 1: Heated Seat Sensor Reference Voltage
    G01164039Courtesy of DAIMLERCHRYSLER CORP.

* In reference to the table above (Fig 1 ), the LO/HI Set Point is the point at which the voltage will stabilize. As the temperature of the seat cushion rises the voltage on the return signal circuit or seat temp volts should also steadily rise until the set point is reached. Once the heat level or set point is reached, the memory heated seat/mirror module will toggle the heating elements ON/OFF to maintain the set point or temperature. The cold seat specification is measured with the vehicle stabilized in a 65°F shop or garage.

Keep in mind that the seat temp voltage or return signal voltage is monitored on the PCI DATA BUS circuit and should set a diagnostic trouble code if shorted hi/lo or open. Always check for any stored trouble codes in the memory heated seat/mirror module before attempting any service or diagnostics of the system. Also, never erase stored trouble codes until the problem has been identified, this way you can keep a record of your progress.