LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2000 >> Intrepid Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Seat Heating System) >> Heated Seat Element >> Diagnosis And Testing - Heated Seat Element >> Notes

Diagnosis And Testing - Heated Seat Element: Notes

WARNING: This page is about a different car, the 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, and 2003 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.

The following procedure will check the heated seat elements as well as the related seat wire harness and connectors. This way, if there is a fault with the seat wire harness leading to the heated seat element or connector(s) it can also be detected. Without checking the heated seat element in this way, a fault with the seat wire harness or connector(s) would not be detected.

The heated seat elements in the seat cushion and seat back are connected in series with each other and the controlling module. With the system wired this way, if a open or fault occurs the entire seat may not heat, even though the open may only be in the seat cushion element.

Over time, the heated seat element may degrade and require replacement. The memory heated seat/mirror module should detect a fault before the element completely fails. Always use the appropriate scan tool (DRB III(R)) to check the module for any stored fault codes prior to any testing of the individual heated seat components.

NOTE: When checking heated seat elements for continuity, be certain to move the heating element being checked. Moving the element, such as sitting in the seat will eliminate the possibility of an intermittent open in the element which would only be evident if the element was in a certain position. Failure to check the element in various positions could result in an incomplete test.