Test 15F: Odometer No Bus Message
NOTE:
For connector terminal identification and wiring diagrams, see
BODY CONTROL COMPUTER - INTRODUCTION article. Perform VERIFICATION TEST VER-1
after each repair.
CAUTION:
Always turn ignition off prior to disconnecting any module connector.
- Disconnect audio CD player. Using external ohmmeter, measure resistance between ground and Body Control Module (BCM) Gray 14-pin connector terminal No. 5 (Violet/Yellow wire). If resistance is 9-11 k/ohms, replace audio CD player. If resistance is not 9-11 k/ohms, go to next step.
- Disconnect audio CD player bus wire from radio (Violet/Yellow wire). If resistance is 9-11 k/ohms, repair short to ground in Violet/Yellow wire. If resistance is not 9-11 k/ohms, go to next step.
- Disconnect radio connectors. If resistance is 9-11 k/ohms, replace radio. If resistance is not 9-11 k/ohms, repair short to ground in Violet/Yellow wire between BCM and radio.