LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1999 >> LHS >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Vehicle Communications System >> Symptom Id Tests >> Test 15C: Odometer No Bus Message

Test 15C: Odometer No Bus Message

NOTE: For connector terminal identification and wiring diagrams, see BODY CONTROL COMPUTER - INTRODUCTION article. Perform VERIFICATION TEST VER-1  after each repair.
CAUTION: Always turn ignition off prior to disconnecting any module connector.
  1. Disconnect Overhead Travel Information System (OTIS) module, if equipped. OTIS module is mounted to headliner. Turn ignition on. If odometer does not display NO BUS, replace OTIS module. If odometer displays NO BUS, go to next step.
  2. Turn ignition off. Disconnect Memory Heated Seat/Mirror Module (MHSMM), if equipped. MHSMM is located under drivers seat. Turn ignition on. If odometer does not display NO BUS, replace MHSMM module. If odometer displays NO BUS, go to next step.
  3. Turn ignition off. Disconnect Transmission Control Module (TCM), if equipped. TCM is located at left fenderwell, next to power distribution center in engine compartment. Turn ignition on. If odometer does not display NO BUS, replace TCM module. If odometer displays NO BUS, go to next step.
  4. Turn ignition off and disconnect Powertrain Control Module (PCM). PCM is located next to air cleaner. Turn ignition on. If odometer does not display NO BUS, replace PCM module. If odometer displays NO BUS, go to next step.
  5. Turn ignition off. Disconnect anti-lock brake controller module. Anti-lock brake controller module is mounted on left inner fender panel. Turn ignition on. If odometer does not display NO BUS, replace anti-lock brake controller module. If odometer displays NO BUS, go to next step.
  6. Turn ignition off. Disconnect Automatic Temperature Control (ATC) head. Turn ignition on. If odometer does not display NO BUS, replace ATC head. If odometer displays NO BUS, go to next step.
  7. Turn ignition off and wait 5 minutes. Disconnect Air Bag Control Module (ACM) 23-pin connector. ACM is located under center console. Turn ignition on. If odometer does not display NO BUS, replace ACM module. If odometer displays NO BUS, go to next step.
  8. Disconnect audio CD player connector, if equipped. Turn ignition on. If odometer does not display NO BUS, replace audio CD player . If odometer displays NO BUS, go to next step.
  9. Disconnect radio connector, if equipped. Turn ignition on. If odometer does not display NO BUS, replace radio. If odometer displays NO BUS, go to next step.
  10. Disconnect Sentry Key Immobilizer Module (SKIM) connector. SKIM is located at ignition switch. Turn ignition on. If odometer does not display NO BUS, replace SKIM. If odometer displays NO BUS, go to next step.
  11. Disconnect BCM Gray 14-pin connector. Connect jumper wire between BCM Gray 14-pin connector terminals No. 13 and No. 14. Using scan tool, select MIC CLUSTER. If odometer does not display NO BUS, replace BCM. If odometer displays NO BUS, replace instrument cluster.