No Crank Reference Signal At Pcm (DTC 11)
NOTE:
For connector terminal ID, see CONNECTOR IDENTIFICATION. For wiring diagram, see WIRING DIAGRAMS - 3.3L
article in ENGINE PERFORMANCE. After each repair, perform TEST VER-2
.
- Using scan tool, erase trouble codes. Attempt to start engine. If necessary, crank engine for at least 10 seconds. Read trouble codes. If scan tool displays NO SIGNAL or CAM ONLY, go to step 5). If scan tool does not display NO SIGNAL or CAM ONLY, go to next step.
- At this time, the condition required to set trouble code is not present. NO SIGNAL or CAM ONLY trouble code sets if Powertrain Control Module (PCM) does not see crank signal with cam signal present. Possible causes are: open 8-volt power supply at Crankshaft Position (CKP) sensor, open or shorted CKP sensor signal wire, open CKP sensor ground, failed CKP sensor, improperly adjusted CKP sensor, failed PCM, or failed transmission control module. Go to next step.
- Inspect CKP sensor wiring and connectors. Clean and repair wiring and connectors as required. If wiring and connectors are okay, go to next step.
- Start engine. Wiggle wiring harness from CKP to PCM. If engine misses or stalls when wiring harness is wiggled, repair wiring harness where wiggling caused problem. If engine does not miss or stall when wiring harness is wiggled, see INACTIVE TROUBLE CODE CONDITION . Test is complete.
- If scan tool displays NO SIGNAL or CAM ONLY in step 1), turn ignition off. Disconnect Crankshaft Position (CKP) sensor connector. Using scan tool in voltmeter mode, check voltage on CKP sensor connector terminal No. 1 (Orange wire). If voltage is less than 7 volts, go to TEST TC-2B. If voltage is more than 7 volts, go to next step.
- Connect one end of a jumper wire to CKP sensor connector terminal No. 3 (Light Blue/Dark Blue wire). Turn ignition on. Using scan tool, read DIS signal status. Observe scan tool while tapping other end of jumper wire to CKP sensor connector terminal No. 2 (Black/Light Blue wire). If scan tool displays CRANK ONLY, replace CKP sensor. If scan tool does not display CRANK ONLY, go to next step.
- Disconnect jumper wire. Using scan tool in ohmmeter mode, check resistance of CKP sensor connector terminal No. 2 (Black/Light Blue wire). If resistance is more than 5 ohms, repair open Black/Light Blue wire. If resistance is less than 5 ohms, go to next step.
- Ensure ignition is off. Disconnect Powertrain Control Module (PCM) connector. PCM is located under air cleaner. Inspect PCM connector. Repair any terminals that are damaged, pushed out or miswired. If PCM connector is okay, go to next step.
- Using an external ohmmeter, check resistance of Light Blue/Dark Blue wire between CKP sensor connector terminal No. 3 and PCM connector terminal No. 24. If resistance is more than 5 ohms, repair open Light Blue/Dark Blue wire. If resistance is less than 5 ohms, go to next step.
- Using scan tool in ohmmeter mode, check resistance of PCM connector terminal No. 24 (Light Blue/Dark Blue wire). If resistance is more than 5 ohms, replace PCM. If resistance is less than 5 ohms, go to next step.
- Disconnect Transmission Control Module (TCM) connector. TCM is located in engine compartment between left front fender and battery. Check resistance of PCM connector terminal No. 24 (Light Blue/Dark Blue wire). If resistance is more than 5 ohms, replace TCM. If resistance is less than 5 ohms, repair short to ground in Light Blue/Dark Blue wire.