Inspecting Idle Air Control Motor Operation
NOTE:
For connector terminal ID, see CONNECTOR IDENTIFICATION. For wiring diagram, see WIRING DIAGRAMS - 3.3L
article in ENGINE PERFORMANCE. After each repair, perform TEST VER-1
.
- Turn ignition off. Disconnect Powertrain Control Module (PCM) connector. PCM is located under air cleaner. Inspect all terminals. Repair as required. If PCM terminals are okay, go to next step.
- Using an external ohmmeter, check resistance of Yellow/Black wire between IAC motor connector terminal No. 2 and PCM connector terminal No. 60. If resistance is less than 5 ohms, replace PCM. If resistance is more than 5 ohms, repair open Yellow/Black wire.