LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1992 >> LeBaron LX, 2D Convertible >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 3.0L >> No-Fault Tests >> Test NF-9A - Checking Engine Controller Grounds & Power Circuits

Test NF-9A - Checking Engine Controller Grounds & Power Circuits

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION . For appropriate wiring diagram, see WIRING DIAGRAMS .
  1. Turn ignition switch to OFF position. Disconnect and inspect SBEC connector terminals. Repair connector terminals if damaged. Perform VERIFICATION PROCEDURE VER-2 .
  2. If connector terminals are okay, place DRB-II in ohmmeter mode. Probe SBEC connector terminal No. 5 (Black/White wire). If resistance is more than one ohm, repair Black/White wire for an open to ground. Perform VERIFICATION PROCEDURE VER-2 . If resistance is less than one ohm, probe terminal No. 11.
  3. If resistance is more than one ohm, repair Black/Tan wire for an open to ground. Perform VERIFICATION PROCEDURE VER-2 . If resistance is less than one ohm, probe SBEC connector terminal No. 12 (Black/Tan wire). If resistance is more than one ohm, repair Black/Tan wire for an open to ground. Perform VERIFICATION PROCEDURE VER-2 .
  4. If resistance is less than one ohm, place DRB-II in voltmeter mode. Turn ignition switch to ON position. Probe SBEC connector terminal No. 9 (Dark Blue wire). If voltage is less than 10 volts, repair open Dark Blue wire. Perform VERIFICATION PROCEDURE VER-2 . If voltage is more than 10 volts, reconnect SBEC connector. Test is complete.