TEST 61A - Testing Body Controller For No Response
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagrams, see appropriate chassis wiring diagram in the WIRING DIAGRAMS Section.
- Turn ignition switch to OFF position. Disconnect body controller Black connector. Body controller is located behind right kick panel. Check connector condition and clean or repair connector as necessary. Using an external ohmmeter, check resistance at Violet/Brown wire between terminal No. 1 at CCD bus diagnostic connector and terminal No. 7 at body controller Black connector.
- If resistance is more than 5 ohms, repair open Violet/Brown wire. Perform VERIFICATION TEST 6A. If resistance is less than 5 ohms, check resistance at White/Black wire between terminal No. 6 at CCD bus diagnostic connector and terminal No. 20 at body controller Black connector.
- If resistance is more than 5 ohms, repair open White/Black wire. Perform VERIFICATION TEST 6A. If resistance is less than 5 ohms, reconnect DRB-II. Put DRB-II in ohmmeter mode. Probe terminal No. 19 (Black/Light Green wire) at body controller Black connector.
- If resistance is more than 5 ohms, repair open Black/Light Green wire. Perform VERIFICATION TEST 6A. If resistance is less than 5 ohms, put DRB-II in voltmeter mode. Turn ignition switch to ON position with engine off. Probe terminal No. 6 (Dark Blue/White wire) at body controller Black connector.
- If voltage is more than 10 volts, perform TEST 61B. If voltage is less than 10 volts, remove fuse No. 14 from fuse block. Inspect fuse. If fuse is blown, go to step 7). If fuse is okay, probe input terminal to fuse No. 14.
- If voltage is more than 10 volts, repair open Dark Blue/White wire from fuse block. Perform TEST 61B. If voltage is less than 10 volts, repair open in Dark Blue wire between ignition switch and fuse block. Perform VERIFICATION TEST 6A. Perform TEST 61B.
- If fuse No. 14 is blown in step 5), turn ignition switch to OFF position. Replace fuse No. 14. Turn ignition switch to ON position with engine off. Remove and recheck fuse No. 14. If fuse is blown, repair short to ground in Dark Blue/White wire. Perform TEST 61B.
- If fuse is okay, turn ignition switch to OFF position. Reinstall fuse No. 14. Reconnect body controller Black connector. Turn ignition switch to ON position with engine off. Recheck fuse No. 14. If fuse is blown, replace body controller. Perform TEST 61B. If fuse is okay, perform TEST 61B.