TEST 57A - Testing Engine Node For No Response
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagrams, see appropriate chassis wiring diagram in the WIRING DIAGRAMS Section.
- Turn ignition switch to OFF position. Disconnect engine node connector. See Figure . Check connector condition and clean or repair connector as necessary. Turn ignition switch to ON position with engine off. Put DRB-II in voltmeter mode. Probe terminal No. 11 (Dark Blue/White wire) at engine node connector. If voltage is less than 10 volts, go to step 4).
- If voltage is more than 10 volts, turn ignition switch to OFF position. Using an external ohmmeter, check resistance at Violet/Brown wire between terminal No. 1 at CCD bus diagnostic connector and terminal No. 7 at engine node connector. If resistance is more than 5 ohms, repair Violet/Brown wire. Perform VERIFICATION TEST 6A.
- If resistance is less than 5 ohms, check resistance at White/Black wire between terminal No. 6 at CCD bus diagnostic connector and terminal No. 8 at engine node connector. If resistance is more than 5 ohms, repair open White/Black wire. Perform VERIFICATION TEST 6A. If resistance is less than 5 ohms, replace engine node. Perform VERIFICATION TEST 6A.
- If voltage is less than 10 volts at Dark Blue wire in step 1), remove mini-fuse No. 42 in power distribution center. Inspect fuse. If fuse is blown, go to step 6). If fuse is okay, probe input terminal to fuse No. 42.
- If voltage is less than 10 volts, repair of replace power distribution center. Perform VERIFICATION TEST 6A. If voltage is more than 10 volts, repair open in Dark Blue/White wire between power distribution center and fuse block. Perform VERIFICATION TEST 6A.
- If fuse is blown in step 4), put DRB-II in ohmmeter mode. Probe output terminal (in power distribution center) from fuse No. 42. If resistance is less than 5 ohms, repair short to ground in Dark Blue/White wire. If resistance is more than 5 ohms, reconnect engine node connector. Replace fuse No. 42.
- Turn ignition to ON position with engine off. Remove and recheck fuse No. 42. If fuse is blown replace engine node. PERFORM VERIFICATION TEST 6A. If fuse is okay, test is complete.