Installation Procedure
Low Frequency Console Antenna (2) - Install
- Ignition Lock Key Transmitter Antenna Bracket Bolt (1) - Install and tighten [2x] - Fastener Specifications
Connect the electrical connectors and position the wiring harness.
- Front Floor Console Cup Holder Trim Plate (2) - Install
- Front Floor Console Retainer Bolt (1) - Install and tighten [2x] - Fastener Specifications
Front Floor Console Stowage Tray (1) - Install
Front Floor Console Armrest Pivot Pin (1) - Install
- Front Floor Console Storage Tray Bolt (2) - Install and tighten [2x] - Fastener Specifications
Front Floor Console Storage Tray Bolt (1) - Install and tighten [2x] - Fastener Specifications
- Front Floor Console Armrest Hinge Clip (2) - Install
Front Floor Console Cover Bolt (1) - Install and tighten [2x] - Fastener Specifications
Front Floor Console Compartment (1) - Install
- NOTE:
Some components not shown for graphic clarity.
Front Floor Console Bracket Bolt (2) - Install and tighten [4x] - Fastener Specifications
- Front Floor Console Compartment Liner (1) - Install
Front Floor Console Armrest (3) - Install
- Front Floor Console Armrest Pivot Pin (2) - Install
- Front Floor Console Armrest Hinge Clip (1) - Install
- Connect the electrical connector and position the wiring harness.
Front Floor Console Rear Trim Panel (2) - Install
- Front Floor Console Rear Cover Bolt (1) - Install and tighten - Fastener Specifications
Front Floor Console Rear Cup Holder (3) - Install
- Front Floor Console Cup Holder Bolt (2) - Install and tighten - Fastener Specifications
- Front Floor Console Rear Cup Holder Liner (1) - Install
Connect and position the wiring harness.
- Front Floor Rear Console Side Trim Panel - Right Side (1) - Install
Front Floor Rear Console Side Trim Panel - Left Side (1) - Install
Front Floor Console Rear Trim Lower Panel (1) - Install
Front Floor Console Bolt Access Hole Cover - Left Side and Right Side (1) - Install [2x]
Front Floor Console Extension Panel - Right Side (1) - Install
Front Floor Console Extension Panel - Left Side (3) - Install
- Front Floor Console Extension Bolt (2) - Install and tighten - Fastener Specifications
- Front Floor Console Extension Panel Bolt Access Hole Cover (1) - Install
Front Floor Console Trim Plate (1) - Install
Front Floor Console Applique - Left Side and Right Side (1) - Install [2x]
Front Seat - Left Side and Right Side (2) - Install [2x] - Front Seat Removal and Installation
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (9C1 / 5W4) , or Battery Negative Cable Disconnection and Connection (KL9)
- Return the armrest compartment to the close position.
Refer to Fastener Caution .
Make sure the liner is properly seated under the front floor console compartment bezel.