Installation Procedure
Transmission Fluid Cooler Outlet Pipe (4) @ Transmission - Connect - Transmission Fluid Cooler Hose / Pipe Quick-Connect Fitting Disconnection and Connection
Transmission Fluid Cooler Outlet Pipe (2) - Install
- Transmission Fluid Cooler Outlet Pipe Bolt (1) - Install and tighten - Fastener Specifications
Transmission Fluid Cooler Outlet Pipe Seal (3) - Install NEW
- Transmission Fluid Cooler Outlet Pipe (2) - Install
- Transmission Fluid Cooler Outlet Pipe Nut (1) - Install and tighten - Fastener Specifications
- Raise the transmission.
Transmission Mount (2) - Install
- Transmission Mount Transmission Side Bolt (1) - Install and tighten in sequence [4x] - Fastener Specifications
Transmission Mount Bolt (1) - Install and tighten [2x] - Fastener Specifications
Transmission Mount Brace (2) - Install
- Transmission Mount Brace Bolt (1) - Install and tighten [2x] - Fastener Specifications
- Remove the transmission jack.
Battery Tray (2) - Install
- Install the retainers.
- Battery Tray Bolt (1) - Install and tighten - Fastener Specifications
Battery Cover (1) - Install
Battery (1) - Install
Battery Hold Down Retainer (2) - Install
- Battery Hold Down Retainer Bolt (1) - Install and tighten - Fastener Specifications
Battery Hold Down Retainer (3) - Install
- Install the electrical connector (2).
- Battery Hold Down Retainer Bolt (1) - Install and tighten - Fastener Specifications
Engine Control Module Bracket (2) - Install
- Battery Hold Down Retainer Nut (1) - Install and tighten - Fastener Specifications
Connect the wiring harness retainers as necessary.
- Radiator Surge Tank Outlet Hose Clip (1, 2) - Install
Engine Control Module (2) - Install
- Connect the electrical connectors. (1)
Connect the electrical connector.
- Battery Distribution Engine Compartment Fuse Block (5) - Install
- Install wiring harness terminals.
- Battery Negative Post Clamp Nut (4) - Install and tighten - Fastener Specifications
- Battery Positive Cable Junction Block Nut (3) - Install and tighten [2x] - Fastener Specifications
- Engine Wiring Harness Fuse Block Nut (2) - Install and tighten [2x] - Fastener Specifications
Power Distributor Fuse Block Cover (1) - Install
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Fill the transmission to the proper level with NEW transmission fluid. Transmission Fluid Level and Condition Check
- Inspect for transmission fluid leaks.
- Remove the drain pan.
- Install underbody panels as necessary. Underbody Panel Component Locator
Refer to Fastener Caution
The stated fastener removal or installation sequence must be followed to avoid damage to the components of the mount assembly.