Installation Procedure
- CAUTION:
Ensure the Outer Tie Rod Boot is not twisted or deformed during assembly. If the boot is twisted or deformed, damage to the boot will occur.
If reusing the steering linkage outer tie rod (1), add a small amount of grease on the lip of the rubber boot seal to prevent twisting or deforming of the boot. Do NOT apply grease to the ball joint stud. Adhesives, Fluids, Lubricants, and Sealers
- Steering Linkage Outer Tie Rod (1) - Install
- CAUTION:
Steering Linkage Outer Tie Rod Nut (1) - Install and tighten - Fastener Specifications
Tighten the steering linkage inner tie rod nut (1) during the front toe adjustment procedure.
- Install the front tire and wheel assembly. Tire and Wheel Removal and Installation (Steel Wheel)Tire and Wheel Removal and Installation (Aluminum Wheel)
- Measure and adjust the front toe. Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment