LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2021 >> Tahoe SSV >> Repair and Diagnosis >> Collision >> Body Panels >> Body Panel Replacement >> Body Panel Replacement >> Quarter Inner Panel Extension Replacement (SWB - Sectioning) >> Removal Procedure

Removal Procedure

Fig 1: Quarter Inner Panel Extension Replacement Component Location (SWB - Sectioning)
GM5478638Courtesy of GENERAL MOTORS COMPANY
WARNING:

Refer to Collision Sectioning Warning .

NOTE:

Left shown, right similar.

NOTE:

The quarter reinforcement is mild steel. MILD STEEL

  1. Disable the SIR system. SIR Disabling and Enabling .
  2. Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection (9C1, 5W4)Battery Negative Cable Disconnection and Connection (KL9)
  3. Remove all related panels and components.
  4. Remove bodyside. Body Side Outer Panel Replacement (SWB) Body Side Outer Panel Replacement (LWB) , or Body Side Outer Panel Sectioning (SWB) Body Side Outer Panel Sectioning (LWB) .
  5. Remove the sealers and anti-corrosion materials from the repair area as necessary. Anti-Corrosion Treatment and Repair
    GM5478641Courtesy of GENERAL MOTORS COMPANY
  6. NOTE:

    Utilize a cut location that allows for 25 mm of distance from pass though holes and radii for ease of install.

  7. Section the quarter reinforcement within the recommended shaded area (1).
    GM5478642Courtesy of GENERAL MOTORS COMPANY
  8. NOTE:

    Do not damage or cut attaching panels and reinforcements

  9. Remove spot welds (1). [24x]
  10. Remove spot welds (2). [16x]
  11. Remove spot welds (3). [3x]
    GM5478640Courtesy of GENERAL MOTORS COMPANY
  12. Remove quarter reinforcement (1) from the vehicle.