LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2021 >> Tahoe SSV >> Repair and Diagnosis >> Collision >> Body Panels >> Body Panel Replacement >> Body Panel Replacement >> Front Wheelhouse Panel Reinforcement Replacement >> Removal Procedure

Removal Procedure

Fig 1: Front Wheelhouse Panel Reinforcement Replacement Component Location
GM5357734Courtesy of GENERAL MOTORS COMPANY
WARNING:

Refer to Collision Sectioning Warning .

NOTE:

Left shown, right similar.

NOTE:

The wheelhouse panel is mild steel. MILD STEEL .

  1. Disable the SIR system. SIR Disabling and Enabling .
  2. Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection (9C1, 5W4)Battery Negative Cable Disconnection and Connection (KL9)
  3. Remove all related panels and components.
  4. Remove front fender bracket. Front Fender Bracket Replacement 
  5. Remove the sealers and anti-corrosion materials from the repair area as necessary. Anti-Corrosion Treatment and Repair
    GM4902245Courtesy of GENERAL MOTORS COMPANY
  6. NOTE:

    Do not damage or cut attaching panels and reinforcements.

  7. Remove all spot welds (1). [6x]
  8. Remove all spot welds (2). [9x]
    GM4902238Courtesy of GENERAL MOTORS COMPANY
  9. Remove all spot welds (1). [7x]
    GM4902237Courtesy of GENERAL MOTORS COMPANY
  10. NOTE:

    Do not damage or cut attaching panels and reinforcements.

    NOTE:

    Use 6.7 mm (17/64") holes for rivet installation.

  11. Drill 6.7 mm (17/64") hole to remove all spot welds (1). [2x]
    GM4902241Courtesy of GENERAL MOTORS COMPANY
  12. Apply heat to shaded area (1) to release adhesive.
    GM4902243Courtesy of GENERAL MOTORS COMPANY
  13. Remove wheelhouse panel (1) from the vehicle.
  14. Remove remaining adhesive from vehicle.