Component Testing
S13 Door Lock Switch - Test
- Ignition/Vehicle - Off
- Disconnect the appropriate electrical connector: S13 Door Lock Switch
- Test for infinite resistance between the test points:
- Signal terminal 2 & Ground terminal 4 - Lock Switch - Not Pressed
- Signal terminal 3 & Ground terminal 4 - Unlock Switch - Not Pressed
- If less than infinite resistance
Replace the component: S13 Door Lock Switch
- Go to next step: If infinite resistance
- Test for less than 3 ohms between the test points: Signal terminal 2 & Ground terminal 4 - Lock Switch - Pressed
- If 3 ohms or greater
Replace the component: S13 Door Lock Switch
- Go to next step: If less than 3 ohms
- If 3 ohms or greater
- Test for less than 3 ohms between the test points: Signal terminal 3 & Ground terminal 4 - Unlock Switch - Pressed
- If 3 ohms or greater
Replace the component: S13 Door Lock Switch
- Go to next step: If less than 3 ohms
- If 3 ohms or greater
- All OK.
M14 Door Lock Actuator - Test
- Ignition/Vehicle - Off
- Disconnect the electrical connector: M14 Door Lock Actuator
- Connect a 25 A fused jumper wire between the test points: Control terminal A & B+
- Momentarily connect a jumper wire between the test points: Control terminal B & Ground
- Reverse the jumper wires 2 times between the terminals.
Verify the component works as specified: M14 Door Lock Actuator = Lock & Unlock
- If not the specified state
Replace the component: M14 Door Lock Actuator
- Go to next step: If the specified state
- If not the specified state
- All OK.
CAUTION:
Complete the testing as quickly as possible in order to prevent overheating and damaging the component.