LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2019 >> Spark LS, Standard Trans >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Vehicle Access System >> Diagnostic Information and Procedures >> DTC B3140 or B3150 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition/Vehicle - Off
  2. Disconnect the electrical connector: S13D Door Lock Switch - Driver & S13P Door Lock Switch - Passenger
  3. Ignition - On / Vehicle - In Service Mode
  4. Verify the scan tool parameter: Driver Door Lock Switch = Inactive
    • If not the specified state 
    1. Ignition/Vehicle - Off
    2. Disconnect the electrical connector: X6 & X7K9 Body Control Module
    3. Test for infinite resistance between the test points:
      • S13D Door Lock Switch - Driver: Signal circuit terminal 2 @ Component harness & Ground
      • S13D Door Lock Switch - Driver: Signal circuit terminal 4 @ Component harness & Ground
      • S13P Door Lock Switch - Passenger: Signal circuit terminal 2 @ Component harness & Ground
      • S13P Door Lock Switch - Passenger: Signal circuit terminal 4 @ Component harness & Ground
      • If less than infinite resistance - Repair the short to ground on the circuit.
      • If infinite resistance - Replace the component: K9 Body Control Module
    • Go to next step: If the specified state 
  5. Ignition/Vehicle - Off
  6. Connect the electrical connector: S13D Door Lock Switch - Driver
  7. Ignition - On / Vehicle - In Service Mode
  8. Operate the component: S13D Door Lock Switch - Driver - Lock & Unlock

    Verify the scan tool parameter: Driver Door Lock Switch = Lock & Unlock

    • If not the specified state 

      Test or replace the component: S13D Door Lock Switch - Driver

    • Go to next step: If the specified state 
  9. Ignition/Vehicle - Off
  10. Connect the electrical connector: S13P Door Lock Switch - Passenger
  11. Ignition - On / Vehicle - In Service Mode
  12. Operate the component: S13P Door Lock Switch - Passenger - Lock & Unlock

    Verify the scan tool parameter: Passenger Door Lock Switch = Lock & Unlock

    • If not the specified state 

      Test or replace the component: S13P Door Lock Switch - Passenger

    • Go to next step: If the specified state 
  13. All OK.