Installation Procedure
- Install the electronic parking brake control module to the bracket.
- CAUTION:
Refer to Fastener Caution .
Install the electronic parking brake control module bolts (1) and tighten to 9 N.m (80 lb in).
- Install the electronic parking brake control module and bracket assembly to the lower insulator stud.
Install the electronic parking brake control module bracket nuts (1) and tighten to 9 N.m (80 lb in).
- Inspect the O-ring seals on the electronic parking brake control module spindle and the parking brake front cable nut for damage and correct positioning and replace, if necessary.
- NOTE:
The electronic parking brake control module spindle must be held stationary while installing the parking brake front cable nut to avoid distorting the spindle housing.
Install the parking brake front cable nut (1) and tighten to 6 N.m (53 lb in).
- Connect the electronic parking brake control module electrical connector.
- Install the left rear wheelhouse liner. Refer to Rear Wheelhouse Liner Replacement .
- Install the left rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
- Enable the parking brake cable adjuster. Refer to Parking Brake Cable Adjuster Enabling .
NOTE:
A small amount of denatured alcohol may be used as a lubricant on the bracket insulator to ease installation.