LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Volt Premier >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 1.5L (L3A) - Repair Instructions >> Repair Instructions >> Evaporative Emission Pipe Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Bumper
    GM4773254Courtesy of GENERAL MOTORS COMPANY
  1. If replacing the evaporative emissions pipe with a new pipe, position the new bumper (1) on the new replacement pipe, after installation, as shown. If the old pipe is being reinstalled, position a new bumper (1) on the existing pipe, after installation, as shown.
  2. Fig 2: Evaporative Emission Pipe Sleeve
    GM4253982Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Check sleeve for proper position after pipe installation.

  3. If replacing the evaporative emissions pipe with a new pipe and the new pipe does not have a sleeve (1) on it, transfer the sleeve (1) from the old pipe to the new one.
  4. Fig 3: Evaporative Emission Pipe And Retainers
    GM4091108Courtesy of GENERAL MOTORS COMPANY
  5. Install the evaporative emission pipe (2) to the vehicle.
  6. Install Evaporative Emission Pipe(2)@Retainer(1)
  7. Close the 5 retainers (1).
  8. Fig 4: Drive Motor Generator Control Module Cooling Outlet Hose
    GM4854762Courtesy of GENERAL MOTORS COMPANY
  9. Remove all EN-6015  plugs from the connections.
  10. Connect Evaporative Emission Pipe (1) @Evaporative Emission Canister(2)Plastic Collar Quick Connect Fitting Service 
  11. Install Drive Motor Generator Control Module Cooling Outlet Hose(4)Drive Motor Generator Control Module Cooling Outlet Hose Replacement (Underbody Line)Drive Motor Generator Control Module Cooling Outlet Hose Replacement (Underbody Line to Traction Power Inverter Module Inlet)
  12. Install Evaporative Emission Pipe (1) @Retainer (3)
  13. Close the retainer (3).
  14. Install Floor Panel Number 4 Cross Bar Floor Panel Number 4 Cross Bar Replacement
  15. Install Rear Axle Rear Axle Replacement
  16. Fig 5: Evaporative Emission Pipe And Retainers
    GM4091106Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Inspect bulkhead cross car brake line and retainers as required after line installation.

  17. Install Evaporative Emission Pipe(2)@Retainer(1)
  18. Close the 2 retainers (31).
  19. Install Drivetrain and Front Suspension Cradle Drivetrain and Front Suspension Cradle Replacement
  20. Lower the vehicle.
  21. Fig 6: Evaporative Emission Pipe And Evaporative Emission Canister Purge Solenoid Valve
    GM4854761Courtesy of GENERAL MOTORS COMPANY
  22. Install Evaporative Emission Pipe(1)@Retainer(2)
  23. Close Retainer(2)
  24. Remove all EN-6015  plugs from the connections.
  25. Connect Evaporative Emission Pipe(1)@Evaporative Emission Canister Purge Solenoid Valve(3) Plastic Collar Quick Connect Fitting Service 
  26. Install Air Cleaner Outlet Duct Air Cleaner Outlet Duct Replacement 
  27. Connect Battery Negative Cable Battery Negative Cable Disconnection and Connection