LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2016 >> Volt Premier >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 1.5L (L3A) - Repair Instructions >> Repair Instructions >> Evaporative Emission Pipe Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Evaporative Emission Pipe Sleeve
    GM4253982Courtesy of GENERAL MOTORS COMPANY
  1. If replacing the evaporative emissions pipe with a new pipe and the new pipe does not have a sleeve (1) on it, transfer the sleeve (1) from the old pipe to the new one.
  2. Fig 2: Evaporative Emission Pipe And Retainers
    GM4091108Courtesy of GENERAL MOTORS COMPANY
  3. Install the evaporative emission pipe (2) to the vehicle.
  4. Install Evaporative Emission Pipe (2) @ Retainer (1) (Qty: 5)
  5. Close the 5 retainers (1).
  6. Install the left side fuel tank strap. Refer to Fuel Tank Replacement .
  7. Fig 3: Evaporative Emission Pipe, Evaporative Emission Canister And Retainer
    GM4091107Courtesy of GENERAL MOTORS COMPANY
  8. Remove all EN-6015  plugs from the connections.
  9. Connect Evaporative Emission Pipe (1) @ Evaporative Emission Canister (2). Refer to Plastic Collar Quick Connect Fitting Service 
  10. Install Evaporative Emission Pipe (1) @ Retainer (3)
  11. Close the retainer (3).
  12. Install Floor Panel Number 4 Cross Bar. Refer to Floor Panel Number 4 Cross Bar Replacement
  13. Install Drive Motor Battery. Refer to Drive Motor Battery Replacement and Shipping Preparation
  14. Fig 4: Evaporative Emission Pipe And Retainers
    GM4091106Courtesy of GENERAL MOTORS COMPANY
  15. Install Evaporative Emission Pipe (2) @ Retainers (1) (Qty: 2)
  16. Close the 2 retainers (1).
  17. Install Drivetrain and Front Suspension Cradle. Refer to Drivetrain and Front Suspension Cradle Installation
  18. Lower the vehicle.
  19. Fig 5: Evaporative Emission Canister Purge Solenoid Valve And Evaporative Emission Pipe
    GM4091105Courtesy of GENERAL MOTORS COMPANY
  20. Install Evaporative Emission Pipe (1) @ Retainer (2)
  21. Close the retainer (2).
  22. Remove all EN-6015  plugs from the connections.
  23. Connect Evaporative Emission Pipe (1) @ Evaporative Emission Canister Purge Solenoid Valve (3). Refer to Plastic Collar Quick Connect Fitting Service 
  24. Install Air Cleaner Outlet Duct. Refer to Air Cleaner Outlet Duct Replacement 
  25. Connect Battery Negative Cable. Refer to Battery Negative Cable Disconnection and Connection