LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Cruze Diesel >> Repair and Diagnosis >> Engine Mechanical >> Engine Exhaust System >> Repair Instructions >> Warm Up Three-Way Catalytic Converter Replacement >> Installation Procedure

Installation Procedure

  1. Install the heated oxygen sensor 1 to the three way warm up catalytic converter. Refer to Heated Oxygen Sensor Replacement - Sensor 1 .
  2. NOTE:

    Never re-use the V-clamp.

  3. Pre-install a NEW three way warm up catalytic converter V-clamp.
  4. Install the three way warm up catalytic converter to the turbocharger and the three way warm up catalytic converter brackets. Install a NEW three way warm up catalytic converter to turbocharger seal ring.
  5. Fig 1: Catalytic Converter Bracket Nuts
    GM2192215Courtesy of GENERAL MOTORS COMPANY
  6. Install and hand-tighten the 2 three way warm up catalytic converter bracket nuts (1) and (2).
  7. Lower the vehicle.
  8. Install the three way warm up catalytic converter V-clamp to the catalytic converter to turbocharger flange.
  9. Fig 2: Catalytic Converter V-Clamp
    GM2191860Courtesy of GENERAL MOTORS COMPANY
  10. The three way warm up catalytic converter V-clamp (1) should be installed in the shown position.
  11. Hand-tighten the three way warm up catalytic converter V-clamp.
  12. Raise and support the vehicle.
  13. CAUTION:

    Refer to Fastener Caution .

  14. Tighten the 2 three way catalytic converter bracket nuts to 22 (16 lb ft).
  15. Fig 3: Catalytic Converter
    GM2192214Courtesy of GENERAL MOTORS COMPANY
  16. Install the catalytic converter (3) and a NEW catalytic converter gasket (1) to the three way warm up catalytic converter.
  17. Install the 3 NEW catalytic converter flange nuts (2) and tighten to 22 (16 lb ft).
  18. Install the engine front compartment insulator if equipped. Refer to Front Compartment Insulator Replacement
  19. Lower the vehicle.
  20. Tighten the three way catalytic converter V-clamp bolt to 13 (115 lb in).
  21. Install the exhaust manifold heat shield. Refer to Exhaust Manifold Heat Shield Replacement (1.4L LUV) , Exhaust Manifold Heat Shield Replacement (1.8L LUW and LWE) .
  22. Connect the heated oxygen sensor 1 wiring harness plug. Refer to Heated Oxygen Sensor Replacement - Sensor 1 .
  23. Connect battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
  24. Close the hood.