Catalytic Converter Replacement - Left Side
Courtesy of GENERAL MOTORS COMPANY Catalytic Converter Replacement - Left Side
| Callout |
Component Name |
|
Preliminary Procedure
- Remove the floor panel tunnel panel reinforcement. Refer to Floor Panel Tunnel Panel Reinforcement Replacement
.
- Remove the heated oxygen sensor. Refer to Heated Oxygen Sensor Replacement - Bank 1 Sensor 2
.
- Place an adjustable jack stand underneath the intermediate pipe to support the exhaust system during service.
- Disconnect the catalytic converter from the intermediate pipe. Refer to Intermediate Pipe Replacement .
|
| 1 |
Catalytic Converter-to-Exhaust Manifold Fasteners (Qty: 4)
Procedure
- Remove the exhaust manifold fasteners and DISCARD.
- Install NEW exhaust manifold fasteners.
Tighten 50 (37 lb ft) |
| 2 |
Exhaust Manifold Studs Procedure
- Remove the exhaust manifold studs and DISCARD.
- Install NEW exhaust manifold studs.
Tighten 22 (16 lb ft) |
| 3 |
Catalytic Converter Procedure Install a NEW exhaust manifold gasket. |