LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Caprice >> Repair and Diagnosis >> Body & Frame >> Fixed And MOVEABLE Windows >> Repair Instructions >> Rear Side Door Window Regulator Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Window Regulator
    GM1940040Courtesy of GENERAL MOTORS CORP.
  1. Position the window regulator (1) through the large access hole in the door (2).
  2. Fig 2: Identifying Window Regulator To Door Retaining Bolts
    GM1940041Courtesy of GENERAL MOTORS CORP.
    CAUTION:

    Refer to Fastener Caution .

  3. Install the window regulator to door retaining bolts (1) and tighten to 8 N.m (71 lb in).
  4. Remove the support from the window.
  5. Lower the window into the window regulator clamps.
  6. Fig 3: Identifying Window Regulator Electrical Connector
    GM1939957Courtesy of GENERAL MOTORS CORP.
  7. Connect the window regulator electrical connector (1).
  8. Start the vehicle to make sure maximum power to the window motor. This is required to fully seat the window for adjustment.
  9. Raise the window to the full up position.
  10. Fig 4: Identifying Window Regulator To Window Retaining Bolts
    GM1940042Courtesy of GENERAL MOTORS CORP.
  11. Tighten the window regulator to window glass retaining bolts (1) to 8 N.m (71 lb in).
  12. Inspect the window for correct operation and a tight seal.
  13. Shut off the vehicle.
  14. Install the water deflector. Refer to Rear Side Door Water Deflector Replacement .
  15. Install the speaker. Refer to Radio Rear Side Door Speaker Replacement .
  16. Install the door trim panel. Refer to Rear Side Door Trim Panel Replacement .