Installation Procedure
- Install the outer tie rod assembly (3) to the inner tie rod assembly (1). Do NOT tighten the jam nut (2).
- Install the outer tie rod assembly (2) to the steering knuckle (1).
- Install the prevailing torque nut (2) to the outer tie rod assembly (1).
Tighten: Tighten the nut to 30 N.m (22 lb ft) plus 120 degrees. Visually inspect to ensure that 2 1/2 to 4 1/2 threads are visible past the nylon washer.
- Install tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
- Lower the vehicle.
- Perform a front end alignment. Refer to Wheel Alignment Measurement .
CAUTION:
Refer to Fastener Caution
.