LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Chevy Express G2500, Van Passenger >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Wiring Systems And Power Management - Introduction >> Repair Instructions >> Accessory Wiring Junction Block Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Junction Block Base Tabs
    GM881131Courtesy of GENERAL MOTORS CORP.
  1. Install the junction block base by sliding tabs (2) in and pressing in tabs (1) until they are locked.
  2. Fig 2: Chassis Harness, I/P Harness, Engine Harness, & Forward LP Harness
    GM881126Courtesy of GENERAL MOTORS CORP.
  3. Install into the junction block base the chassis harness (1), the I/P harness (2), the engine harness (3), and the forward LP harness (4).
  4. Fig 3: Fuse Relay Center
    GM881124Courtesy of GENERAL MOTORS CORP.
  5. Install the fuse relay center into the junction block.
  6. Install the fuse block center bolts.
  7. Install the harness ends on the fuse block relay center.
  8. Install the harness end nuts.
  9. Fig 4: Press Tabs Inward To Lift And Remove Large Junction Block Cover
    GM2081295Courtesy of GENERAL MOTORS CORP.
  10. Press tabs (1) inward to lift and remove the large junction block cover (2).
  11. Fig 5: Press Tabs Inward To Lift And Remove Small Junction Block Cover
    GM2081294Courtesy of GENERAL MOTORS CORP.
  12. Press tabs (1) inward to lift and remove the small junction block cover (2).
  13. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .