LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Optra LS, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 2.0L (Diesel) >> Diagnostic Information and Procedures >> DTC P0105, P0107, or P0108 >> Circuit/System Testing

Circuit/System Testing

  1. Verify the integrity of the entire air induction system by inspecting for the following conditions:
    • Damaged components
    • Loose or improper installation
    • Any vacuum leak
    • Verify there are no restrictions in the turbocharger pressure sensor port or vacuum source.
    • If a condition is found, repair as necessary.
  2. Ignition OFF, and the MAIN fuse removed, disconnect the harness connector at the turbocharger boost pressure sensor.
  3. Test for less than 5 ohms between the low reference circuit terminal 4 and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
  4. Install the MAIN fuse. Ignition ON, test for 4.8-5.2 volts between the 5-volt reference circuit terminal 2 and ground.
    • If less than the specified range, test the 5-volt reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
    • If greater than the specified range, test the 5-volt reference circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  5. Verify the scan tool MAP sensor parameter is less than 24 kPa.
    • If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  6. Install a 3A fused jumper wire between the signal circuit terminal 1 and the 5-volt reference circuit terminal 2. Verify the MAP sensor parameter is between 40-45 kPa.
    • If less than the specified range, test the signal circuit for an open or a short to ground. If the circuit tests normal, replace the ECM.
    • If greater than the specified range, test the signal circuit for a high resistance. If the circuit tests normal, replace the ECM.
  7. If all circuits test normal, test or replace the turbocharger boost pressure sensor.