LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Impala SS >> Repair and Diagnosis >> Brakes >> Anti-Lock Brake System & Traction Control System >> Diagnostic Information and Procedures >> Traction Off Indicator Inoperative >> Test Description

Test Description

The number below refers to the step number on the diagnostic table.

  1. 3:  This step tests if the instrument panel cluster (IPC) is able to turn ON the Traction Off indicator.
Traction Off Indicator Inoperative

Step Action Yes No
Schematic Reference: Antilock Brake System Schematics 
Connector End View Reference: Antilock Brake System Connector End Views  or Displays And Gages Connector End Views
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle
2
  1. Turn OFF the ignition for 5 seconds.
  2. Turn ON the ignition while observing the Traction Off indicator.
Does the Traction Off indicator illuminate for 2 seconds and then turn OFF?
Go to Diagnostic Aids  Go to Step 3 
3 
  1. Install a scan tool.
  2. Select the Instrument Panel Cluster (IPC) Special Functions menu on the scan tool.
  3. Command the IPC lamps ON.
Does the Traction Off indicator turn ON?
Go to Step 5  Go to Step 4 
4 Replace the IPC. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.
Did you complete the replacement?
Go to Step 6  -
5 Replace the electronic brake control module (EBCM). Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.
Did you complete the replacement?
Go to Step 6  -
6
  1. Turn OFF the ignition for 5 seconds.
  2. Turn ON the ignition while observing the Traction Off indicator.
Does the Traction Off indicator illuminate for 2 seconds and then turn OFF?
System OK Go to Step 3