Installation Procedure
- Clip the contact ring on the steering wheel, if necessary.
- Align the match-marks on the steering wheel and the steering column shaft. Turn the signal cancelling cam on the wheel to the left.
- Install the retaining clip and the steering wheel nut.
Tighten: Tighten the steering wheel nut to 38 N.m (20 lb ft) .
- Bend the tabs to secure the retaining clip.
- Install the SIR module. Refer to Inflatable Restraint Steering Wheel Module Replacement (Except North America Vehicles) or Inflatable Restraint Steering Wheel Module Replacement (North America Vehicles) in SIR.
- Connect the negative battery cable.
IMPORTANT:
In order to correctly install the steering wheel, match-mark the steering column shaft to the steering wheel.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.