LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Uplander LS >> Repair and Diagnosis >> Body & Frame >> Windows >> Door System, Mirror System & Window System >> Diagnostic Information and Procedures >> DTC B1395 >> Test Description

Test Description

The numbers below refer to the step numbers on the diagnostic table.

  1. 2:  This step tests the PSDM for the optical sensor 5-volt reference and ground.
  2. 6:  The optical sensor needing replacement is part of the PSD motor/clutch assembly and is not serviced separately.
DTC B1395

Step Action Values Yes No
Schematic Reference: Power Sliding Door (PSD) Schematics 
Connector End View Reference: Power Door Systems Connector End Views 
1 Did you perform the Diagnostic System Check - Vehicle? - Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2  Measure the voltage between the 5-volt reference circuit and the low reference circuit of the optical sensor, at the power sliding door module (PSDM) connector.
Is the voltage within the specified value?
4.5-5.5 V Go to Step 3  Go to Step 4 
3 Inspect and if possible repair any damage to the optical sensor pigtail harness or connector. Refer to Wiring Repairs and Connector Repairs in Wiring Systems.
Did you find and correct the condition?
- Go to Step 7  Go to Step 6 
4 Inspect for poor connections at the PSDM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?
- Go to Step 7  Go to Step 5 
5 Replace the PSDM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.
Is the repair complete?
- Go to Step 7  -
6  Replace the power sliding door (PSD) motor and clutch assembly. Refer to Motor Clutch Replacement - Power Sliding Door (With RPO E58 RH)  or Motor Clutch Replacement - Power Sliding Door (With RPO E59 LH) .
Is the repair complete?
- Go to Step 7  -
7 Re-initialize the PSD and operate the system in order to verify the repair.
Did you correct the condition?
- System OK Go to Step 2