LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Uplander LS >> Repair and Diagnosis >> Body & Frame >> Windows >> Door System, Mirror System & Window System >> Diagnostic Information and Procedures >> DTC B1293 >> Test Description

Test Description

The numbers below refer to the step numbers on the diagnostic table.

  1. 3:  Tests the PSDMs ability to provide power and ground to energize the clutch.
DTC B1293

Step Action Yes No
Schematic Reference: Power Sliding Door (PSD) Schematics 
Connector End View Reference: Power Door Systems Connector End Views 
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2
  1. Connect a test lamp across the clutch battery positive voltage and ground circuits, at the power sliding door module (PSDM).
  2. Press the power sliding door (PSD) OPEN/CLOSE switch.
Does the test lamp illuminate?
Go to Step 3  Go to Step 5 
3  Inspect and if possible repair any damage to the motor and clutch pigtail harnesses or connectors. Refer to Wiring Repairs and Connector Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 6  Go to Step 4 
4 Replace the PSD motor and clutch assembly. Refer to Motor Clutch Replacement - Power Sliding Door (With RPO E58 RH)  or Motor Clutch Replacement - Power Sliding Door (With RPO E59 LH) .
Is the repair complete?
Go to Step 6  -
5 Replace the PSDM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.
Is the repair complete?
Go to Step 6  -
6 Re-initialize the power sliding door and operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 2