LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Uplander LS >> Repair and Diagnosis >> Body & Frame >> Windows >> Door System, Mirror System & Window System >> Diagnostic Information and Procedures >> DTC B1292 >> Test Description

Test Description

The numbers below refer to the step numbers on the diagnostic table.

  1. 2:  Tests the ability of the PSDM to provide power and ground to operate the PSD motor.
  2. 6:  The motor and clutch assembly are packaged as an assembly and are not serviced separately.
DTC B1292

Step Action Yes No
Schematic Reference: Power Sliding Door (PSD) Schematics 
Connector End View Reference: Power Door Systems Connector End Views 
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2 
  1. Disconnect the power sliding door (PSD) motor connector from the power sliding door control module (PSDM).
  2. Connect a test lamp across the motor control circuit terminals from the PSDM.
  3. Manually close the PSD.
  4. Turn the PSD ON/OFF switch ON.
  5. Press the PSD OPEN/CLOSE switch.
Does the test lamp flash?
Go to Step 3  Go to Step 5 
3 Inspect and if possible repair any damage to the PSD motor or clutch pigtail harnesses or connectors. Refer to Wiring Repairs andConnector Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 6  Go to Step 4 
4 Replace the PSD motor and clutch assembly. Refer to Motor Clutch Replacement - Power Sliding Door (With RPO E58 RH)  or Motor Clutch Replacement - Power Sliding Door (With RPO E59 LH) .
Is the repair complete?
Go to Step 6  -
5 Replace the PSDM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.
Is the repair complete?
Go to Step 6  -
6  Re-initialize the PSD and operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 2